lundi 28 février 2011

OIL FILTER


i've ordered an oil filter bracket for the beezer, received this morning. but not good, the fittings are in wrong position so impossible to put it properly. i've decided to build it myself, first step

MADE IN......




thanks to Rowan and Tony for the stickers

SPROCKET TOOL



i ' ve builded this one to have the possiblity to tighten the sproket nut without the rear wheel in place, it works well.

vendredi 25 février 2011

OIL LINES





well, after a fu****' week, i've found a moment today to work on the beezer .Phil made me a cool little weld on the stainless T . it's now possible to assembly all the system, exept the filter, i'm waiting for the bracket, at last i've decided to buy one instead off build it, lazy but overbooked and impatient

jeudi 17 février 2011

LIGHT UPDATE





some little progress everywhere, the oil fittings are done, front end is finished, except the cables.
i've installed the primary to see where i can install the oil filter properly, actually the filter bracket does'nt exist, i must build it before

mardi 15 février 2011

FRONT END




today i've rebuilded the front wheel, it 's not really a succes. first thing, spokes and nipples was chromed so after some tightens it was a recall , then due at my first wrong assembly , some spokes are twisted.... ideally i will change them for stainless spokes but later, at this time, i would like to start the engine soon and have lot of details unfinished.....

TEN YEARS..

my brother JAKEZ
06/52 - 02/01
R I P

dimanche 13 février 2011

W I P




now the bike is on the lifter. the fork is OK, next step will be the finish of the front wheel with maybe a modification of the drum, but before i have to clean the bench...

samedi 12 février 2011

SETTINGS DONE




well, after a lot of mishaps, one more time, the settings are done. the engine is closed. big time.
next step will be the oil lines and fittings

jeudi 10 février 2011

FKC NEWS





Marcos from FREE KUSTOM CYCLES send me some pics of his latest build. nice bike with cool details. thanks for the pics mate

mardi 8 février 2011

OIL FITTINGS





at last i've decided to build myself the oil fittings.it's not easy to find what you want, especially the separator who have two differents inside diameters, the pump fittings are make like gas spigots, if it's good for gas, it will be good for oil too

samedi 5 février 2011

WEB POWER



last monday i've broken my 2 ba tap when i was machining my last special nut for the dynamo. i've talked about that with some friends cause 2 ba tap is not usual here. and yesterday in the letterbox, i found that, sended by QM from BRITISHIRONWORKS, great and good surprise. thanks a lot mate, it's very appreciated. now the nut is done

jeudi 3 février 2011

SPROCKET NUT TOOL




today i've machined the tool to tighten the sprocket nut. i made some modifications on the sprocket to have the chain in the same axe than the rear sprocket , so the usual tool doesn't fit now. i've machined this one who work perfectly, good day

mercredi 2 février 2011

MAGDYNO ON BOARD





well, this time it's good, the magdyno is on the engine, after the settings, logically, that's done for that. can't beleive......

DYNAMO WIRING



the dark side of my system.....