mardi 31 janvier 2012

DISORDER IN THE HOUSE



it was, due at the cleaning of the cases. i've some other works planned on the beezer, it was time to make place. the shed is not enough wide , or the bike is too long....

dimanche 22 janvier 2012

THE RETURN OF MISTER SPOKE



well, it was foreseeable and it' s arrived, taiwan spokes, 30 years patina in 6 months... no comment.
i've ordered a stainless set at CWC Birmingham, received yesterday. i'll rebuild that next month , when i will remove the dynamo .

vendredi 20 janvier 2012

CASES UPDATE


some progress on the timing side case, boring job, i've ordered some "abrasives" but not arrived at this time. so i must work with worn sand paper.......

jeudi 19 janvier 2012

BADMAN NICO METALWORKS






a few times ago i met a guy, who became a friend. in fact it's a neighbour, located around 10 km from here....look at the scooters, the metal forming is awesome. Nico build himself the machines, have a look on his blog , there's a lot of work pics. theses pics are stolen on his blog
click the title to go to

vendredi 13 janvier 2012

CRANKCASES


i've begun the polishing of the other set of cases. not sure if it's really a good idea, the casting is infamous. far from finished.......

mercredi 11 janvier 2012

SHED PICS






not really a fantastic progress, i've finished the side stand pivot. at this time i need help to move the bike and material to continue the job. in the same time , i've received some stickers from Netherlands, thanks Sjoerd.

lundi 9 janvier 2012

samedi 7 janvier 2012

KRAZY HORSE IRONHEADS






a few pics of the last Hayride, when i look through the window, i've the blues of summertime... some well knows heads on pics, hi mates.

jeudi 5 janvier 2012

ONE MORE.....





the motormounts, bolts and nuts are done, all in stainless steel. next step will to the search of a 16 rear wheel,the rear mudguard is not the definitive.

lundi 2 janvier 2012

ONE STEP FORWARD, TWO STEPS BEHIND



well, i found some gas this morning and finished the motormount bolts. i began the "special nuts " but it's not possible to install them due at a bad alignment of the bits of tube, i must cut them to replace properly, unhappy.....