jeudi 20 mars 2014

AND A DISASTER,TO FOLLOW

spend a lot of time to weld the rear anchor on the frame and nothing good. the tube is cracking just after the weld, all around !!! asked the owner, who make the frame, and it appears he don't use the good tube to do it. in fact he used what he found, i made some test, in the best case thickness is 2,5 mm, sometimes less than that. will be a crap festival all along the build. best way is to find another frame, this one will be broken quickly, especially in off road ......................bad karma

lundi 17 mars 2014

A GOOD NEW

got this pipes from http://www.hawkshawmotorcycles.com/ ,   it was a request of the owner . when i found them i've asked the seller about shipping cost : he said how much and add, if you can wait a week, i'll bring them with us, Jim & Chris have a house  nearly 40 km from here, world is small . so last sat they came here with the spares, good contact, kind people, perfect


they're installed, i must cheat everywhere cause Triumph frame is single tube, not this one. it's very close but OK

dimanche 16 mars 2014

REAR MOTORMOUNT


i 'm at half way for the rear brackets, anchors are done and installed, just a few points of weld at this time, must remove the engine to weld that

dimanche 9 mars 2014

ON ANY SUNDAY

the engine is at the right place, front bracket OK, made in aircraft alloy

, i'll probably change the final look, still searchin' . i'm working on the rear bracket , trying to do something efficient, as nothing exist....then the two bottom anchor....

mercredi 5 mars 2014

CHALLENGE ONE SPIRIT




well, after a long hibernation there's a new project in the shed , not a chopper this time . i'll build this one for a friend, it's a kinda Rickman metisse replica frame, very close to BSA A 10 with a Triumph T 100C inside .
very close from the beginning at this time, first step : install the engine properly and in line